菜单

你的设置

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的17指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 6

步骤 6
Slide the pick along the edge of the display, towards the headphone jack. If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat. Be careful not to let the opening pick slide between the fused LCD and front panel, as doing so can permanently damage the display.

  • Slide the pick along the edge of the display, towards the headphone jack.

  • If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat.

  • Be careful not to let the opening pick slide between the fused LCD and front panel, as doing so can permanently damage the display.

  • A good rule of thumb is to never insert the opening pick more than a quarter inch (6 mm) into the iPad.

将撬片在显示屏边缘处一直滑动到耳机孔处。

如果在滑动的时候遇到了很大的阻力，请重新加热iOpener，来进一步融化粘合剂。

小心，切勿使撬片在LCD显示屏与前面板之间滑动，这样将会永久损坏显示屏。

法则就是，永远不要把撬片插入iPad超过1/4英寸。（约0.6cm）

[* black] Slide the pick along the edge of the display, towards the headphone jack.
[* black] If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat.
[* icon_caution] Be careful not to let the opening pick slide between the fused LCD and front panel, as doing so can permanently damage the display.
[* icon_note] A good rule of thumb is to never insert the opening pick more than a quarter inch (6 mm) into the iPad.
[* icon_note] A good rule of thumb is to never insert the opening pick more than a quarter inch (6 mm) into the iPad.

在开源创作共享许可协议下，你的投稿已被许可。