注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的25本指南

英语
中文

正翻译步骤 3

步骤 3
Slide the pick along the bottom edge of the phone to slice through the adhesive securing the rear glass. Afterward, it may help to leave the pick in place and grab a second pick as you proceed to the next step. Leaving the pick inserted can help prevent the glue you just separated from re-adhering.
  • Slide the pick along the bottom edge of the phone to slice through the adhesive securing the rear glass.

  • Afterward, it may help to leave the pick in place and grab a second pick as you proceed to the next step. Leaving the pick inserted can help prevent the glue you just separated from re-adhering.

  • Re-heat the rear glass as needed to prevent the glue from cooling and hardening.

本步骤还使用了一个塑料撬片,用来将后部面板从中框分离。如果双面胶的粘性仍然很强,用iOpener再加热一次。

使用吸盘在面板中部用力,旋转你的手腕向上拉后部的边缘。

[* icon_note] The following steps involve using an openingblack] Slide the pick to separatealong the rear panel frombottom edge of the midframe. Ifphone to slice through the adhesive is too strong, reapply heat withsecuring the iOpenerrear glass.
[* black] Usingicon_note] Afterward, it may help to leave the suction cup, apply pressurepick in place and grab a second pick as you proceed to the middle section ofnext step. Leaving the panel while pulling uppick inserted can help prevent the lower edge by pivoting your wristglue you just separated from re-adhering.
[* icon_note] Re-heat the rear glass as needed to prevent the glue from cooling and hardening
.
[* icon_note] The following steps involve using an openingblack] Slide the pick to separatealong the rear panel frombottom edge of the midframe. Ifphone to slice through the adhesive is too strong, reapply heat withsecuring the iOpenerrear glass.
[* black] Usingicon_note] Afterward, it may help to leave the suction cup, apply pressurepick in place and grab a second pick as you proceed to the middle section ofnext step. Leaving the panel while pulling uppick inserted can help prevent the lower edge by pivoting your wristglue you just separated from re-adhering.
[* icon_note] Re-heat the rear glass as needed to prevent the glue from cooling and hardening
.

在开源创作共享许可协议下,你的投稿已被许可