跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 3

步骤 3
Remove the three 4.5mm Phillips screws on the fan assembly. Loosen the seven captive Phillips screws in the ascending numerical order (1-7).  Numbers are printed next to each screw on the housing. Screws will not fully come off the assembly. You need to only loosen them.
  • Remove the three 4.5mm Phillips screws on the fan assembly.

  • Loosen the seven captive Phillips screws in the ascending numerical order (1-7). Numbers are printed next to each screw on the housing.

  • Screws will not fully come off the assembly. You need to only loosen them.

  • Remove the fan assembly from the system board by lifting it straight up.

  • For reassembly, you will need to clean the old thermal paste off of areas highlighted in yellow as well as matching parts on the fan assembly. Following that, you would need to reapply thermal paste before putting back the fan assembly. Small amount of the size of the rice grain should be enough for each plate.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可