翻译步骤＃15 - Apple Watch Force Touch Sensor Replacement - iFixit

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南。

英语

中文

上一步下一步

正翻译步骤 15

步骤 15

If you're using a replacement battery that came with pre-installed adhesive, peel off the protective tab now, exposing the adhesive.

If needed, try re-using the existing adhesive to secure the battery. Alternatively, try a small piece of double-sided tape such as Tesa 61395, or a dab of liquid adhesive such as E6000.

Rotate the battery down into its slot, and press it into position.

If you're using a replacement battery that came with pre-installed adhesive, peel off the protective tab now, exposing the adhesive.
If needed, try re-using the existing adhesive to secure the battery. Alternatively, try a small piece of double-sided tape such as Tesa 61395, or a dab of liquid adhesive such as E6000.
Rotate the battery down into its slot, and press it into position.
Press the battery down against the system board to re-adhere it in place.
Now is the best time to test powering on your watch—if it doesn't turn on, double check all three connectors and try again.

在开源创作共享许可协议下，你的投稿已被许可。