注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的3指南

英语
中文

正翻译步骤 3

步骤 3
The bracket that contains the display and digitizer cable connections is made up of an upper and lower piece. The connectors are secured to the lower, and the upper must be removed to disconnect them. Use fine-tipped tweezers to grasp the lower half of the bracket. There is a small metal tab that protrudes downward from the upper metal bracket.
  • The bracket that contains the display and digitizer cable connections is made up of an upper and lower piece. The connectors are secured to the lower, and the upper must be removed to disconnect them.

  • Use fine-tipped tweezers to grasp the lower half of the bracket.

  • There is a small metal tab that protrudes downward from the upper metal bracket.

  • Insert a small (1 mm) flathead screwdriver between the tab and the lower bracket, and rotate the screwdriver to spread the gap.

  • This will release two tabs that hold the upper bracket to the lower, and should free the upper bracket.

固定显示器和数字转化器的排线的支架是由上、下两片构成的,接头被固定在较低那片,上面那片必须被移除以断开它们

你可以用尖嘴镊子夹住支架的下半部分

有一个小的金属铭牌在上片金属支架上朝下突出

在金属铭牌与下片金属支架之间插入一个小(1mm)平头螺丝刀,缓缓转动螺丝刀以分开两部分

这会使上下两片分开,金属支架就自由啦~\(≧▽≦)/~啦啦啦

在开源创作共享许可协议下,你的投稿已被许可