跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
法语

正翻译步骤 1

步骤 1
The capacitor can store electricity even when the camera is off! Do not touch it until you have safely discharged it. Connect the two capacitor wires briefly with a pair of metal tweezers to discharge the capacitor.  You may see a small spark. Remove eight screws using a Phillips #00 screwdriver.
  • The capacitor can store electricity even when the camera is off! Do not touch it until you have safely discharged it.

  • Connect the two capacitor wires briefly with a pair of metal tweezers to discharge the capacitor. You may see a small spark.

  • Remove eight screws using a Phillips #00 screwdriver.

  • Two (4.31 mm) screws are in the front of the camera.

  • Two (3.30 mm) screws are located in the bottom of the camera.

  • This causes the tripod mount on the bottom to become loose.

  • Four (3 x 3.33 mm and 1 x 4.34 mm) screws are in the back of the camera.

Le condensateur peut stocker de l'électricité même lorsque l'appareil photo est éteint! Ne le touchez pas avant de l'avoir déchargé en toute sécurité.

Connectez brièvement les deux fils du condensateur avec une paire de pinces métalliques pour le décharger. Vous pouvez voir une petite étincelle.

Retirez 8 vis.

2 vis à l'avant (2X 4,31 mm).

2 vis en bas (2X3.30MM).

4 vis à l'arrière (3x 3,33 mm et 1x 4,34 mm).

[* icon_caution] The capacitor can store electricity even when the camera is off! Do not touch it until you have safely discharged it.
-[* blue] Connect the two capacitor wires briefly with a pair of metal tweezers to discharge it. You may see a small spark.
-[* black] Remove 8 screws.
- [* orange] 2 screws in the front (2X 4.31mm).
- [* yellow] 2 screws on the bottom (2X3.30MM).
- [* red] 4 screws in the back (3x 3.33mm, and 1x 4.34mm).
+[* red] Connect the two capacitor wires briefly with a pair of metal tweezers to discharge the capacitor. You may see a small spark.
+[* black] Remove eight screws using a Phillips #00 screwdriver.
+ [* orange] Two (4.31 mm) screws are in the front of the camera.
+ [* yellow] Two (3.30 mm) screws are located in the bottom of the camera.
+ [* icon_note] This causes the tripod mount on the bottom to become loose.
+ [* green] Four (3 x 3.33 mm and 1 x 4.34 mm) screws are in the back of the camera.

在开源创作共享许可协议下,你的投稿已被许可