跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南

英语
中文

正翻译步骤 1

步骤 1
Remove the following screws securing the heat sink to the logic board: Four 8.6 mm T8 Torx screws
  • Remove the following screws securing the heat sink to the logic board:

  • Four 8.6 mm T8 Torx screws

  • One 2.9 mm T6 Torx screw

  • Be careful not to lose the springs held beneath each of the T8 heat sink screws, they may fall off of the screws as you remove them.

  • During reassembly, tighten these screws evenly to ensure the heat sink stays flat against the CPU.

卸下将散热器固定到主板上的螺丝如下:

四个8.6毫米T8 Torx螺钉

一个2.9毫米T6 Torx螺钉

小心不要丢失固定在每个T8散热器螺钉下方的弹簧,当它们卸下时,它们可能从螺钉上脱落。

在重组时,均匀拧紧这些螺丝,以保证散热片平贴在CPU上。

在开源创作共享许可协议下,你的投稿已被许可