注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的2本指南

英语
中文

正翻译步骤 6

步骤 6
Lift the hard drive from the edge nearest the logic board and remove it from the mini, minding the RAM socket and any cables that may get caught. When reinstalling the hard drive, be sure the two T8 Torx lugs on its far end are inserted into the two rubber grommets highlighted in red in the second picture before sliding the logic board back into place.
  • Lift the hard drive from the edge nearest the logic board and remove it from the mini, minding the RAM socket and any cables that may get caught.

  • When reinstalling the hard drive, be sure the two T8 Torx lugs on its far end are inserted into the two rubber grommets highlighted in red in the second picture before sliding the logic board back into place.

从最靠近逻辑板的边缘提起硬盘驱动器,将其从mini中取出,注意RAM插槽和任何可能被卡住的电缆。

重新安装硬盘驱动器时,确保将其远端的两个T8梅花接线片插入第二张图中以红色突出显示的两个橡胶垫圈中,然后将逻辑板滑回到位。

在开源创作共享许可协议下,你的投稿已被许可