跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的11本指南

英语
中文

正翻译步骤 7

步骤 7
Remove the following five screws securing the Wi-Fi antenna to the logic board:
  • Remove the following five screws securing the Wi-Fi antenna to the logic board:

  • One 2.3 mm Phillips

  • Two 1.6 mm Phillips

  • One 1.4 mm Phillips

  • One 4.8 mm Phillips

  • When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless.

  • Also make sure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad Wi-Fi reception after reassembly.

松开把WiFi天线固定在主板上的5颗螺丝:

1颗2.3mm飞利浦螺丝

2颗1.6mm飞利浦螺丝

1颗1.4mm飞利浦螺丝

1颗4.8mm飞利浦螺丝

重组机器时最先拧4.8mm飞利浦螺丝然后拧2.3mm飞利浦螺丝。这样可以确保不会混淆,避免打穿损坏LCD显示屏和触摸板。

重装机器时确保长的4.8mm飞利浦螺丝装回到正确的位置。这颗螺丝是WiFi天线的接地线,是引起WiFi信号差的元凶在重装机器后。

在开源创作共享许可协议下,你的投稿已被许可