跳转到主内容
英语
中文

正翻译步骤 2

步骤 2
Use an iPod opening tool to slightly lift the top edge of the connector cover away from the logic board. Use the tip of a spudger to pull the connector cover retaining clips away from the inner frame. Remove the connector cover from the iPhone.
  • Use an iPod opening tool to slightly lift the top edge of the connector cover away from the logic board.

  • Use the tip of a spudger to pull the connector cover retaining clips away from the inner frame.

  • Remove the connector cover from the iPhone.

  • Before reassembly, be sure to clean all metal-to-metal contact points on the connector cover with a de-greaser such as windex. The oils on your fingers have the potential to cause wireless interference issues.

  • There is a tiny metal part on the top screw hole, make sure this stays on. It's a key part of the wireless and GPS antenna.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可