跳转到主内容

修复你的物品

维修的权力

商店

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的5本指南

英语
中文

正翻译步骤 6

步骤 6
Remove the battery from the iPhone.
  • Remove the battery from the iPhone.

  • If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the the ribbon cable.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.

  • Adhere the battery, disconnect it, and continue reassembling your device.

  • If your new battery doesn’t have adhesive preinstalled, refer to this guide to replace the adhesive strips.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

将电池从机身中取出。

如果你的更换电池上有塑料纸,请在安装之前把塑料纸去掉。

当你安装电池时,可使用本指南对易拉胶进行更换。

在安装好电池后请进行“硬件重置”(电源键+HOME键长按10s至iPhone重新启动),这样可以避免出现一些状况和使问题简单化。

[* black] Remove the battery from the iPhone.
[* icon_note] If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the the ribbon cable.
[* icon_reminder] WhenIf there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
[* icon_reminder] Before you adhere
the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled,
refer to [guide|56465|this guide] to replace your battery'sthe adhesive strips.
[* icon_reminder] WhenIf there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
[* icon_reminder] Before you adhere
the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled,
refer to [guide|56465|this guide] to replace your battery'sthe adhesive strips.
[* icon_reminder] Perform a [guide|44409|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting.

在开源创作共享许可协议下,你的投稿已被许可