翻译步骤＃2 - iMac Intel 27" EMC 2546 Adhesive Strips Replacement - iFixit

取消

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的2本指南。

英语

中文

上一步下一步

正翻译步骤 2

步骤 2

Before you start placing strips, remove all of the old adhesive from around the perimeter of the rear enclosure.

If you are re-using your existing display, you must also remove the old adhesive from the back of the display.

Before you start placing strips, remove all of the old adhesive from around the perimeter of the rear enclosure.
If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
Peel off the old strips of adhesive using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.
After all the old adhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
Don't skip this step, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

在开源创作共享许可协议下，你的投稿已被许可。