跳转到主内容
英语
中文

正翻译步骤 8

步骤 8
Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board. Remove two screws shown in the second image.  Remove the gray connector on top of the input board. Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board.  Unclip the component from the logic board.
  • Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board.

  • Remove two screws shown in the second image. Remove the gray connector on top of the input board.

  • Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board. Unclip the component from the logic board.

  • Note that there is a clip on both the left and right sides of the input board.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可