跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的18本指南

英语
中文

正翻译步骤 9

步骤 9
Remove the following Phillips screws securing the front panel assembly cable bracket:
  • Remove the following Phillips screws securing the front panel assembly cable bracket:

  • Three 1.2 mm screws

  • One 1.5 mm screw

  • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.

保持前面板张开立起约90度,卸下前面板排线固定板上的五颗Phillips螺丝。

三颗1.2 mm螺丝

一颗1.7 mm螺丝

一颗3.1mm螺丝

[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''
[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''

在开源创作共享许可协议下,你的投稿已被许可