修复你的物品

维修的权力

商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南。

返回指南
英语
西班牙语
上一步 下一步

正翻译步骤 8

步骤 8
Important. When you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.

  • Important. When you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.

  • Use a firm plastic edge to scrape the thermal material off the raised copper heat conduit in three places. Clean the surface with rubbing alcohol.

  • For more advanced instructions on this procedure, see our Applying Thermal Paste Guide.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下，你的投稿已被许可。