修复你的物品

维修的权力

商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南。

返回指南
英语
中文
上一步

正翻译步骤 9

步骤 9
Lift and remove the battery from the iPhone.

  • Lift and remove the battery from the iPhone.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • There should be no resistance. If the battery remains stuck, reheat the iOpener and pry again.

  • If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

  • Before you adhere the replacement battery, temporarily reconnect the battery connector to the motherboard socket. This ensures that the battery is properly aligned in its recess.

  • Adhere the battery, disconnect it, and continue reassembling your device.

  • If your new battery doesn’t have adhesive preinstalled, refer to this guide to replace the adhesive strips.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

从iPhone上提起并取出电池。

该没有阻力。 如果电池仍然卡住，请重新加热iOpener并再次撬动。

如果你的替换电池有塑料纸，在安装之前请从排线处撕除。

安装电池时，请参阅本指南来更换电池的胶带。

重新组装后执行强制重新启动。 这可以防止几个问题并简化故障排除。

[* black] Lift and remove the battery from the iPhone.
[* icon_reminder] If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
[* icon_caution] There should be no resistance. If the battery remains stuck, reheat the iOpener and pry again.
[* icon_note] If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.
[* icon_reminder] When installingBefore you adhere the replacement battery, temporarily reconnect the battery connector to the motherboard socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|107792|this guide] to replace your battery'sthe adhesive strips.
[* icon_reminder] When installingBefore you adhere the replacement battery, temporarily reconnect the battery connector to the motherboard socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|107792|this guide] to replace your battery'sthe adhesive strips.
[* icon_reminder] Perform a [guide|44497|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting.

在开源创作共享许可协议下，你的投稿已被许可。