菜单

你的设置

我的工作台

快速访问设备的指南，配件和论坛
我的购物车

购物车是空的

浏览我们的商店

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的17本指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 15

步骤 15
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use a plastic opening tool or a fingernail to disconnect the LCD cable connector. The LCD and Digitizer connectors are on the same cable assembly, so prying the LCD connector up should disconnect both connectors. Double check that the two cables are fully disconnected before removing the display.

  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use a plastic opening tool or a fingernail to disconnect the LCD cable connector.

  • The LCD and Digitizer connectors are on the same cable assembly, so prying the LCD connector up should disconnect both connectors. Double check that the two cables are fully disconnected before removing the display.

  • When reassembling your phone, the LCD cable may pop off its connector. A blank screen, or white lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

在您进行本步骤操作需要连接或者断开线缆时请确保电池保持在断开的状态。

使用塑料打开工具或者指甲来断开LCD线缆链接头。

显示排线和触摸排线是联在一起的，所以必须同时挑开2根排线。再次检查2根排线是否都已近挑开在取下屏幕前。

当重装机器时，显示排线可能会跑偏扣在座子上。白屏或者有条纹就是因为排线没扣好。如果出现这样的情况，重新扣排线和重启iPhone即可。最好的办法是，重置电池：挑开电池排线然后再扣上即可。

在开源创作共享许可协议下，你的投稿已被许可。