跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的2本指南

英语
中文

正翻译步骤 3

步骤 3
Due to variations between iBook G4 models, your heatsink may have either 5 or 6 screws. We've noted all possible positions for screws in the step below. If there's no screw to remove, then skip to the next screw. Be sure that you remove all necessary screws before attempting to remove the heat sink.
  • Due to variations between iBook G4 models, your heatsink may have either 5 or 6 screws. We've noted all possible positions for screws in the step below. If there's no screw to remove, then skip to the next screw. Be sure that you remove all necessary screws before attempting to remove the heat sink.

  • Remove the following 6 screws and 3 nuts from the heat sink:

  • One 2 mm Phillips extending from a finger on the left edge of the heatsink and adjacent the firewire port (not present on some models)

  • Three 3 mm Phillips from around the fan (some models may only have 2 screws).

  • One 3.5 mm Phillips on the left side of the heat sink (not present on some models).

  • One 4.5 mm Phillips at the top right corner of the heat sink.

  • One 6 mm Phillips at the lower left corner of the heat sink.

  • One 4 mm nut from the right side of the heat sink.

  • Two 4 mm screw nuts with attached springs from either side of the heat sink.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可