跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的3指南

英语
中文

正翻译步骤 6

步骤 6
Pull the battery out of the rear case. If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the ribbon cable. If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
  • Pull the battery out of the rear case.

  • If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the ribbon cable.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.

  • Adhere the battery, disconnect it, and continue reassembling your device.

  • If your new battery doesn’t have adhesive preinstalled, refer to this guide to replace the adhesive strips.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

将电池从后盖拉出。

如果你购买的替换电池在插口排线上有个塑料保护套,在安装前先从这个排线上拔下来。

如果手机中残留有酒精溶液,请在安装新电池之前小心地将其擦掉或让它自然风干。

在固定更换电池之前,暂时将电池连接器重新连接到逻辑板插座。 这可确保电池在其凹槽中正确对齐。

粘上电池,断开连接,然后继续重新组装您的设备。

如果你的电池并没有预先贴好粘合剂,,请参考这份指南来替换您电池的胶带。

重新组装完成后,执行一下手机重启。这样可以避免一些问题,并方便故障检修。

在开源创作共享许可协议下,你的投稿已被许可