跳转到主内容
英语
中文

正翻译步骤 7

步骤 7
Make sure that the cable comes off the centre of the circuit board so the housing will fit over it.
  • Make sure that the cable comes off the centre of the circuit board so the housing will fit over it.

  • Also check that there is about 3mm of stripped cable on top of the circuit board as the strain relief has to fit here (see next photo)

  • Solder the other braid on the other side, in the opposite corner to the core. Try not to extend beyond the edge of the circuit board

  • Carefully file off any solder or cable that extends beyond the end of the circuit board.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可