跳转到主内容
英语
中文

正翻译步骤 6

步骤 6
After removing four Phillips screws securing the inner chassis to the outer case, the guts can be removed in one piece. Controls are routed through two daughterboards; one houses the two push-button elements and the other holds the volume dial. The wireless card is attached to a small interconnect board, converting the four-pin connector found on the logic board into the USB connector used by the wireless card.
  • After removing four Phillips screws securing the inner chassis to the outer case, the guts can be removed in one piece.

  • Controls are routed through two daughterboards; one houses the two push-button elements and the other holds the volume dial.

  • The wireless card is attached to a small interconnect board, converting the four-pin connector found on the logic board into the USB connector used by the wireless card.

  • After a bit too much wiggling, we broke the FM antenna lead where it attaches to the board. Soldering iron to the rescue!

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可