跳转到主内容
英语
中文

正翻译步骤 6

步骤 6
I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward. When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
  • I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.

  • When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.

  • There are two problems, however:

  • Nothing pushes the throttle cable back out when I release the moped's throttle.

  • The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.

  • Please check out my Answers question if you can help me solve this problem! Thanks a lot!

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可