跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南

英语
中文

正翻译步骤 8

步骤 8
Repeat the process of pressing down the spring plate and slightly threading in the screws to install the remaining two heat sink screws. Tighten the screws down a little at a time in the same order that you installed them—in an "X" pattern starting at one corner and then crossing to the opposite corner.
  • Repeat the process of pressing down the spring plate and slightly threading in the screws to install the remaining two heat sink screws.

  • Tighten the screws down a little at a time in the same order that you installed them—in an "X" pattern starting at one corner and then crossing to the opposite corner.

  • Do not over-tighten the screws to avoid damaging the logic board. Just tighten them until they stop against the board.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可