跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 12

步骤 12
Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.
  • Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.

  • Be sure to not use too much WD40 or windex.

  • When cleaning out the glue, do NOT attempt to scrap glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.

  • Cut up two small 1mm pieces of the sticker tape and glue the buttons to the phone to keep them in place.

  • It's very important to make sure the buttons line up exactly with the picture.

清理残留在边界上的胶水。有一点WD40或该小微纤维可以帮助你把所有的胶水清理掉。

不要使用太多的WD40或清洗剂。

清洗胶水时,不要试图将胶水从LCD和框架之间的缝隙中取出。一个向中心或下方的非常小的力将使LED产生裂纹。

剪下两块1毫米宽的胶带,然后将按键粘在手机上,使它们保持在适当的位置。

确保按钮和图片完全一致是很重要的。

在开源创作共享许可协议下,你的投稿已被许可