跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的22本指南

英语
中文

正翻译步骤 4

步骤 4
Insert the flat end of a spudger between the front bezel and the plastic strip attached to the rear bezel near the screw holes at the bottom corners of the display. Rotate your spudger toward the rear bezel to separate it from the front bezel. If necessary, enlarge the gap between the lower edge of the rear bezel and the clutch cover until the two components are completely separated.
  • Insert the flat end of a spudger between the front bezel and the plastic strip attached to the rear bezel near the screw holes at the bottom corners of the display.

  • Rotate your spudger toward the rear bezel to separate it from the front bezel.

  • If necessary, enlarge the gap between the lower edge of the rear bezel and the clutch cover until the two components are completely separated.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可