跳转到主内容
德语
英语

SONOS ZP100 Network Card Replacement

指南信息

= 完成 = 未完成

      描述一下你正在修理的device的特别配件或组件。例如:电池

      创建一个标题。

      这个简短的一两句总结将会出现在搜索结果中。

      在读者深入阅读这份指南之前做好背景信息交流。

      说明(指南)步骤

      第 1 步 — Lets begin!

      With the SONOS ZP100 (ZonePlayer) you can use external speakers to play your music that is streamed to the Sonos ZP100 via WiFi or cable.

      第 2 步 — Remove cover

      The upper cover is fastened with two retaining lugs on the front and two on the sides.

      第 3 步

      Gently try to lift one side with a metal spudger. Make sure not to press in the retaining lug directly, as it can break off very easily.

      第 4 步 — Remove the screws from the upper case

      Using the precision tweezers to remove the sticker in the center of the top chassis.

      第 5 步

      Now turn the device over so you can remove the screws on the bottom.

      第 6 步 — Remove the rubber feet

      Use a spudger to remove the four stuck-on rubber feet. If necessary, use some heat (iOpener / hair dryer) to be able to loosen the feet better.

      第 7 步 — Remove the base plate

      Remove the four 10 mm Phillips screws in the countersinks.

      第 8 步

      Lift the bottom lid up and set it aside. You will need it again.

      第 9 步

      Remove the four 10 mm Phillips screws on the bottom.

      第 10 步

      For a better stand and to avoid damaging the antenna, put the lower cover back on and turn the device over.

      第 11 步 — Remove the upper case

      Lift the top lid straight up on both sides.

      第 12 步

      On the underside of the cover between the screws there are two heat conducting pads that transfer the heat generated from the amplifier-board to the case.

      第 13 步 — Remove the WiFi card

      Press both tabs outwards with our fingernails.

      第 14 步

      Pull the 10-pin flat connector straight off towards the front of the device.

      第 15 步 — Loosen the screws on the network card

      Remove the four 7 mm Phillips screws securing the network card to the case.

      第 16 步 — Lift the network card

      Lift the network card up at an angle and pull it together with the ethernet ports towards the front a little bit out of its fixing on the back.

      第 17 步 — Remove the ribbon cable

      Press the two tabs evenly away from the connector.

      第 18 步 — Turn the network card to the side

      Now you can turn the network card further outwards so it is easier to get to the next connector.

      第 19 步 — Remove the power connection

      Remove the power cable from the network card. The plug is secured by a plastic tab. Push the nose away from the connector to pull it out.

      第 20 步 — Remove network card

      The network card is now completely separated and cut from the power supply.

      第 21 步 — Detach ribbon cable from Network Adapter board

      Press the two tabs evenly away from the socket.

      第 22 步 — Network card

      Front and back of the network card.

      在开源创作共享许可协议下,你的投稿已被许可