跳转到主内容
英语
中文

正翻译步骤 1

步骤 1
Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit. Carefully disconnect the fan connector from the socket, as depicted in the second picture.
  • Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit.

  • Carefully disconnect the fan connector from the socket, as depicted in the second picture.

  • The controller connector panel can be gently pulled out of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.

  • Make sure to not pull out the wires while removing the fan. Doing so may damage the connector wire or the PCB.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可