跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的7指南

英语
中文

正翻译步骤 22

步骤 22
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red). Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it. Repeat this step with the other adhesive strip and remove it.
Remove the remaining adhesive
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red).

  • Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it.

  • Repeat this step with the other adhesive strip and remove it.

  • If either adhesive strip breaks before it's removed, use a plastic card to slice through the remaining adhesive.

注意不要触摸电容器引线或电源背面的任何裸露的焊点(红色框)。

抓住底部边缘显示屏粘着条之一末端的小拉条,然后将小拉条拉向iMac的顶部以将其移除。

对另一条小拉条重复此步骤,然后将其取下。

如果任一条小拉条在拆除前都破裂了,请使用塑料卡切下剩余的胶粘剂。

在开源创作共享许可协议下,你的投稿已被许可