跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 1

步骤 1
Pull on the yellow pull tab at a shallow angle with steady force. If the adhesive becomes hard to pull, you can roll it around a spudger and continue pulling. Continue firmly pulling up on the adhesive strip with constant force. If you're using a spudger, spin it every so often to keep the exposed section of the pull tab as short as possible.
  • Pull on the yellow pull tab at a shallow angle with steady force.

  • If the adhesive becomes hard to pull, you can roll it around a spudger and continue pulling.

  • Continue firmly pulling up on the adhesive strip with constant force. If you're using a spudger, spin it every so often to keep the exposed section of the pull tab as short as possible.

  • This may take a lot of force.

  • These adhesive pull tabs are very prone to snapping in half during this process. Pull as slowly as possible.

  • If the adhesive pull tabs are not stretching, you can fill a plastic dropper or syringe with high concentration isopropyl alcohol and apply a few drops under the left edge of the battery. Give the alcohol a minute to weaken the battery adhesive.

  • Continue this process for each of the three pull tabs, until all are either out or have snapped in half.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可