跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的3指南

英语
意大利语

正翻译步骤 7

步骤 7
Carefully disconnect the two antenna coax cables by prying them straight up from the logic board. Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it. To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.
Disconnect the antennas
  • Carefully disconnect the two antenna coax cables by prying them straight up from the logic board.

  • Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.

  • To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Disconnetti con cautela i due cavi coassiali di antenna alzandoli in verticale dalla scheda logica.

Fai scorrere le pinzette o lo spudger sotto ciascun cavo finché non arrivi vicino allo zoccolo e a quel punto torci l'attrezzo o fai leva per scollegare il connettore.

Per riconnettere ciascun cavo, allinea il connettore sopra il suo zoccolo e quindi premilo verso il basso finché non scatta in posizione.

在开源创作共享许可协议下,你的投稿已被许可