跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的3指南

英语
西班牙语

正翻译步骤 7

步骤 7
Carefully disconnect the two antenna coax cables by prying them straight up from the logic board. Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it. To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.
Disconnect the antennas
  • Carefully disconnect the two antenna coax cables by prying them straight up from the logic board.

  • Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.

  • To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Desconecta cuidadosamente los dos cables coaxiales de la antena, sacándolos directamente de la placa lógica.

Desliza tus pinzas o el extremo plano de tu spudger debajo de cada cable hasta que esté cerca del zócalo, y luego suavemente gíralo o haz una palanca para desconectarlo.

Para volver a conectar cada cable, alinea el conector directamente sobre su enchufe, y luego presiona hacia abajo para que encaje en su lugar.

在开源创作共享许可协议下,你的投稿已被许可