跳转到主内容

修复你的物品

维修的权力

商店

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 12

步骤 12
Lift the battery as a whole up out of the upper case, and remove the battery. Before installing a new battery, remove all the old adhesive from the MacBook Pro's case. With a little luck, you can slowly pull out each strip of adhesive with your fingers.
  • Lift the battery as a whole up out of the upper case, and remove the battery.

  • Before installing a new battery, remove all the old adhesive from the MacBook Pro's case.

  • With a little luck, you can slowly pull out each strip of adhesive with your fingers.

  • Otherwise, soak each section of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with an opening pick or one of the other tools in your kit. This can take quite a bit of work, so be patient.

  • Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry.

  • The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. If any additional films/liners are present that weren't on your original battery, remove them now.

  • Calibrate your newly installed battery: charge it to 100%, and keep charging it for at least 2 more hours. Unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook Pro's SMC.

举起并拿走电池。

在你安装你的新电池之前,先从MacBook Pro机身上铲掉所有胶。

如果你有些小运气,你没准儿能用你的手指将那些胶慢慢撕掉。

不然,你就得用除胶剂浸泡每一块胶2、3分钟,然后再用塑料工具将他们刮掉。这会占用你相当长的一段工服,耐心点儿。

擦掉任何残留的除胶剂,再给你的MacBook Pro一点时间晾干它。

你IFixit工具包里的备用电池上事先已经带有胶。在你揭掉胶上的封条之前先仔细地对照一下电池与机身位置是否合适,然后再把每个电池组严整地粘在它应在的位置上。如果你的新电池上有些多余的胶条在你原来的电池上未曾出现,马上移除它们。

在你使用的电池之前先 校准 它:将其充电至100%,并继续充电至少2小时。拔下电源并正常使用以排空电池。当您看到低电量警告时,请保存您的工作,并保持笔记本电脑一直打开,直到它因电池电量不足而进入睡眠状态。等待至少5个小时,然后不间断地将笔记本电脑充电至100%。

在你安装好你的新电池之后,如果你注意到任何不寻常的举动或是问题,你可能需要重置你MacBook Pro的SMC

在开源创作共享许可协议下,你的投稿已被许可