跳转到主内容

修复你的物品

维修的权力

商店

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南

英语
中文

正翻译步骤 6

步骤 6
If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below. If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier. During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).
  • If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.

  • If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.

  • During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).

  • Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.

如果你成功移除了整个环境光传感器,如第一张照片所示,请继续执行下面的下一步。

如果白色扩散板条脱落并仍然嵌入显示屏中,如第二张照片所示,你将需要使用薄刀片或撬动工具小心地将其沿着顶部边缘撬开。

首先重新施加热量可能会使此任务容易一些。在重新组装过程中,请先将扩散器安装到显示器上,并确保其朝向正确的方向(第一幅图像显示为正面,而第三幅图像显示为背面)。

然后,将环境光传感器放在漫射器顶部。在安装固定听筒/传感器组件的螺钉时,你需要将传感器固定在适当的位置。拧紧螺丝后,传感器将保持在原位并正常工作。

在开源创作共享许可协议下,你的投稿已被许可