跳转到主内容

修复你的物品

维修的权力

商店

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的12指南

英语
中文

正翻译步骤 9

步骤 9
Continue pulling the display down (toward the Lightning port) as needed in order to make a gap large enough for the pick. Slide the pick to the top left corner and cut any remaining adhesive securing the display.
  • Continue pulling the display down (toward the Lightning port) as needed in order to make a gap large enough for the pick.

  • Slide the pick to the top left corner and cut any remaining adhesive securing the display.

  • Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the Face ID sensor array.

根据需要继续向下拉显示器(向闪电端口),以使缝隙足够大。

将拨片滑到左上角,并切掉所有剩余的固定显示屏的粘合剂。

同样,不要将拨片插入超过显示屏边框宽度几毫米的位置,否则可能会损坏Face ID传感器阵列。

在开源创作共享许可协议下,你的投稿已被许可