修复你的物品

维修的权力

商店

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的3本指南。

返回指南
英语
中文
下一步

正翻译步骤 1

步骤 1
Remove the following four press-fit connectors with the flat edge of a plastic spudger or opening tool: Front-facing camera connector.

  • Remove the following four press-fit connectors with the flat edge of a plastic spudger or opening tool:

  • Front-facing camera connector.

  • Rear-facing camera connector.

  • Digitizer connector.

  • The rear-facing camera may be held down to the frame with two sided tape. Try to move the camera with the spudger prior to lifting the motherboard If it does not budge, use the same tool to pry it from the frame to avoid damaging the connector cable in the next step.

通过塑料撬棒末端的扁平部分来移除下列3个压接型连接器：

前置摄像头接头

后置摄像头接头

触摸屏接头

后置摄像头可能被两侧的带子固定在框架上。如果无法移动主板，应先考虑移动摄像头再试图撬起主板。使用塑料撬棒将摄像头从框架上移走来避免在下一个步骤中损坏连接线。

在开源创作共享许可协议下，你的投稿已被许可。