修复你的物品

维修的权力

商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南。

返回指南
英语
中文
上一步

正翻译步骤 43

步骤 43
When reinstalling the logic board assembly: Check the alignment of the rubber vibration dampers, and adjust them as needed. Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.
Logic board installation

  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

主板安装

重新安装主板部件时：

检查橡胶减震器的对准情况，并根据需要进行调整。

将天线电缆束穿过主板和散热器之间的间隙，并在将板降低到位时确保其正确对齐。

在安装时，请确保没有电缆被卡在板下。仔细检查每个标记的位置。

在开源创作共享许可协议下，你的投稿已被许可。