修复你的物品 社区 商店

Extracción del cristal trasero del Huawei Honor 9

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的7指南。

返回指南
英语
西班牙语
上一步 下一步

正翻译步骤 2

步骤 2
Huawei Honor 9 Rear Glass Removal: 步骤 0 中的图像 1，2 Huawei Honor 9 Rear Glass Removal: 步骤 0 中的图像 2，2

  • Secure a suction handle to the lower edge of the rear glass, as close to the edge as possible.

  • If the phone's rear glass is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift the rear glass with the suction cup to create a gap between the glass and the frame.

  • Insert an opening pick into the gap.

  • Don't attempt to insert a pick between the back glass and the frame before creating a gap. The glass is covered with foil from the inside, and by not creating a gap, you risk inserting the pick between the glass and the foil instead, which would permanently damage the foil and ruin the solid color of the back panel.

  • If you have trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

Fija una ventosa en el borde inferior del cristal trasero, lo más cerca posible del borde.

Insertar traducción aquí

Si el cristal trasero del teléfono está roto, es posible que la ventosa no se pegue. Trata de levantarla con cinta adhesiva fuerte o pega la ventosa en su lugar y deja que se cure para que puedas proceder.

Levanta el cristal trasero con la ventosa para crear un espacio entre el cristal y el marco.

Coloca una púa de apertura en el hueco.

Si te resulta difícil, aplica más calor para ablandar aún más el adhesivo. Sigue las instrucciones del iOpener para evitar el sobrecalentamiento.

[* black] Secure a suction handle to the lower edge of the rear glass, as close to the edge as possible.
[* icon_note] If the phone's rear glass is cracked, the suction cup may not stick. Try [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed.
[* black] Lift the rear glass with the suction cup to create a gap between the glass and the frame.
[* black] Insert an opening pick into the gap.
+ [* icon_caution] Don't attempt to insert a pick between the back glass and the frame before creating a gap. The glass is covered with foil from the inside, and by not creating a gap, you risk inserting the pick between the glass and the foil instead, which would permanently damage the foil and ruin the solid color of the back panel.
[* icon_note] If you have trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。