Skip to main content

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的7指南

英语
中文

正翻译步骤 1

Step 1
In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone. For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor. Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.
  • In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone.

  • For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor.

  • Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.

  • Inserting an opening tool more than 3 mm into the phone in this area can damage or tear the fingerprint sensor cable.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可