跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的14本指南

英语
中文

正翻译步骤 1

步骤 1
Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
  • Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • Heat an iOpener and apply it to a long edge of the S8 for about 2 minutes.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

  • As you're waiting for the adhesive to soften, move on and read the following step to get an idea of where to pry.

在S8 的背面较长一端放置加热过的iOpener 大约2分钟。

拆开手机会破坏防水密封。 在继续之前准备好更换粘合剂,如果你在没有更换粘合剂的情况下重新组装手机,请注意避免接触液体。

加热 iOpener 并将其贴在 S8 的长边上约 2 分钟。

你有可能要多次加热iOpener以及将iOpener放置在手机上多次来加热下方的粘合剂。 按照iOpener指南来避免过度加热iOpener。

也可以使用吹风机、热风枪或热板,但要小心不要让手机过热——OLED 显示屏和内部电池都容易受热损坏。

当您在等待粘合剂软化时,请继续阅读以下步骤以了解在何处撬动。

在开源创作共享许可协议下,你的投稿已被许可