跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的6指南

英语
中文

正翻译步骤 3

步骤 3
Heat an iOpener and apply it to the same edge of the phone for two minutes. Apply a suction cup to the back of the phone, as close to the center of the right edge as possible (where the adhesive is narrowest). Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.
  • Heat an iOpener and apply it to the same edge of the phone for two minutes.

  • Apply a suction cup to the back of the phone, as close to the center of the right edge as possible (where the adhesive is narrowest).

  • Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.

  • Insert the point of an opening pick into the gap.

  • Due to tight tolerances, this may take multiple attempts.

  • If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the previous step again.

  • You can try applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.

  • Do not apply excessive force with the pick, or you will risk cracking the back cover glass.

在手机背面使用一个吸盘,尽可能靠近右边缘的中心(粘合剂最窄的地方)。

用强力,稳定的力拉动吸盘,在后盖和框架之间形成间隙。

将开口三角撬片的尖端插入间隙。

由于很紧,这可能需要多次尝试。

如果你在撬开时遇到困难,最好的办法是向边缘施加更多热量并尝试下一步。

您可以尝试在接缝中涂几滴高浓度(超过90%)的异丙醇,以帮助软化粘合剂。

请勿过度用力使用三角撬片,否则可能会使后盖玻璃破裂。

[* black] Heat an iOpener and apply it to the same edge of the phone for two minutes.
[* black] Apply a suction cup to the back of the phone, as close to the center of the right edge as possible ([https://d3nevzfk7ii3be.cloudfront.net/igi/JlRhbQPyRWESV2Cr.full|where the adhesive is narrowest|new_window=true]).
[* black] Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.
[* black] Insert the point of an opening pick into the gap.
[* icon_note] Due to tight tolerances, this may take multiple attempts.
[* black] If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the next stepprevious step again.
[* black] If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the next stepprevious step again.
[* black] You can try applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.
[* icon_caution] Do not apply excessive force with the pick, or you will risk cracking the back cover glass.

在开源创作共享许可协议下,你的投稿已被许可