跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的13指南

英语
中文

正翻译步骤 11

步骤 11
Use the point of a spudger to lift the display cable connector up and out of its socket on the motherboard. Avoid touching the motherboard with the tip of your spudger. The components surrounding the socket are fragile.
  • Use the point of a spudger to lift the display cable connector up and out of its socket on the motherboard.

  • Avoid touching the motherboard with the tip of your spudger. The components surrounding the socket are fragile.

  • To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

  • If any part of your screen doesn't respond to touch after your repair re-seat this connector, making sure it clicks fully into place and that there's no dust or other obstruction in the socket.

  • During reassembly, pause here and replace the adhesive around the edges of the display.

用撬棒一端撬起屏幕排线接口,从主板的底座中移出。

不要用撬棒的尖端直接触碰主板。接口底座附近的组件十分脆弱。

要重新连接这样的排线接口,仔细对齐并按压一端直至其牢固卡入,然后再卡入另一端。不要直接按压排线接口的中间位置。如果没有将接口对齐,接口中的针脚可能会被弄弯,导致永久性损坏。

在维修结束重新连接排线接口后,如果屏幕无法响应触摸操作,确认接口完全卡入位置,并且插槽内没有灰尘及其他物体。

组装屏幕时,请查看下列文章。替换屏幕与边框之间的粘胶

在开源创作共享许可协议下,你的投稿已被许可