跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 5

步骤 5
Use a T5 Torx driver to remove the 13 screws securing the trackpad assembly: Nine 5.8 mm screws
  • Use a T5 Torx driver to remove the 13 screws securing the trackpad assembly:

  • Nine 5.8 mm screws

  • Four 4.9 mm screws

  • These screws look very similar, so don't mix them up.

  • These screws can loosen over time due to the clicking action on the Force Touch trackpad. Adding a little blue threadlocker as you install them can help keep them secure.

  • Install the screws loosely and check the trackpad alignment before tightening them down.

使用T5 Torx 螺丝刀卸下固定触控板组件的13颗螺丝:

九个 5.8 mm 螺丝

四个 4.9 mm 螺丝

这些螺丝看起来非常相似,所以不要混淆它们。

由于 Force Touch 触控板上的点击动作,这些螺丝会随着时间的推移而松动。在安装它们时添加一点缺氧胶可以帮助保证它们的安全。

松散地安装螺丝并检查触控板对齐方式,然后将其拧紧。

在开源创作共享许可协议下,你的投稿已被许可