跳转到主内容

修复你的物品

维修的权力

商店

法语
英语

Mac Pro 2009-2012 Case Replacement

指南信息

= 完成 = 未完成

      描述一下你正在修理的device的特别配件或组件。例如:电池

      创建一个标题。

      这个简短的一两句总结将会出现在搜索结果中。

      在读者深入阅读这份指南之前做好背景信息交流。

      说明(指南)步骤

      第 1 步 — Open the Case

      To open the Mac Pro, you'll have to lift the clip on the back of the case

      第 2 步 — Lift the lateral flap

      Having the flap in the high position, the panel should separate from the box without force

      第 3 步 — Remove the hard drives

      You then have to remove the hard drives. It is simple: pull them towards you with a bit of force.

      第 4 步 — Remove the DVD drives

      Very simple, pull the DVD drives towards you, it should come out with a little force.

      第 5 步 — Remove the board

      Press both latches to unlock the bracket

      第 6 步 — Disconnect the GPU

      Remove the 6 pins or 8 pins connector from your graphics card

      第 7 步 — Disconnect the GPU power supply ( Optional )

      On the power support there is a button, press it and you can move the power supply to the left (see picture)

      第 8 步 — Disconnect GPU support ( optional)

      Disconnect the PCI-e cables from the motherboard

      第 9 步 — Take out the PCI-e fan

      With a screwdriver unscrew the two screws that hold the fan bracket to the board

      第 10 步 — Disconnect the SATA Cables

      Behind the fan bracket there are 2 SATA cables, a 4 pin mini power supply and a 4 pin fan

      第 11 步 — Unscrew CPU support

      With a H3.0 screwdriver, unscrew the screws on the bottom of the bracket (photo 2)

      第 12 步 — Remove the CPU Fan

      Remove the clip at the top of the fan

      第 13 步 — Remove the CPU Fan

      Similar to the top remove the clip at the bottom and pull out the fan.

      第 14 步 — Disconnect Fan and Speakers

      Disconnect the 2 x 4pin fan cables and the 1 x 2 pin speaker cable

      第 15 步 — Remove the CPU Support

      Pull the CPU support towards you

      第 16 步 — Remove the expansion card connector

      Remove the ribbon that connects the motherboard to the expansion card (USB, Jack, Power Off etc.)

      第 17 步 — Remove the expansion card

      Unscrew the 6 screws that hold the card in place.

      第 18 步 — Remove the cover

      unscrew the two screws and remove the cover

      第 19 步 — Unplug the power supply

      Push on both knobs to remove the power connector

      第 20 步 — Separate the power supply

      Unscrew the 4 screws that hold in the power supply

      第 21 步 — Remove the power supply

      Pull the power supply towards you.

      第 22 步 — Detach the bluetooth antenna

      Unclip the bluetooth antenna

      第 23 步 — Remove the mother board

      Unscrew the 10 screws holding in the motherboard

      第 24 步 — Change the case

      Follow the steps in reverse to resemble.

      在开源创作共享许可协议下,你的投稿已被许可