跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的21指南

英语
中文

正翻译步骤 4

步骤 4
Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably. If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst. Insert a second opening pick at the bottom left corner of the iPad.
Slice through the left adhesive
  • Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably.

  • If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst.

  • Insert a second opening pick at the bottom left corner of the iPad.

  • Slide the second opening pick along the left side of the display to separate the adhesive underneath.

  • Leave the opening pick inserted near the top left corner of the iPad to prevent the adhesive from re-sealing.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可