跳转到主内容

iPod Touch 第五代 LCD 屏蔽板更换

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的18本指南

英语
中文

正翻译步骤 1

步骤 1
iPod Touch 5th Generation LCD Shield Plate Replacement: 步骤 0 中的图像 1,2 iPod Touch 5th Generation LCD Shield Plate Replacement: 步骤 0 中的图像 2,2
  • Gently fold the display over away from the rest of the iPod, taking care not to disconnect or break any of the ribbon cables. Set the two halves flat on a table or bench.

  • If your iPod has a black home button assembly rather than the orange one shown here, you can skip this step. The button is not attached to the LCD plate and does not need to be removed to complete the repair.

  • Use a plastic opening tool to pry the home button switch up from the LCD plate.

  • It may be necessary to use a heat gun or hair dryer to soften the adhesive on the back of the home button. Always use a low heat setting.

  • Do not attempt to remove the home button switch, as it is connected to components below the LCD plate.

轻轻地将显示屏折叠远离iPod的其余部分,注意不要断开或断开任何带状电缆。 将两半平放在桌子或长凳上。

使用塑料打开工具从LCD板上撬起Home键开关。

可能需要使用热风枪或吹风机来软化Home键背面的粘合剂。 始终用低热。

因为仍连接到LCD板下面的组件,所以不要尝试移走Home键。

[* icon_note] Gently fold the display over away from the rest of the iPod, taking care not to disconnect or break any of the ribbon cables. Set the two halves flat on a table or bench.
+[* black] ***If your iPod has a black home button assembly rather than the orange one shown here, you can skip this step.*** The button is not attached to the LCD plate and does not need to be removed to complete the repair.
[* black] Use a plastic opening tool to pry the home button switch up from the LCD plate.
[* black] It may be necessary to use a heat gun or hair dryer to soften the adhesive on the back of the home button. Always use a low heat setting.
[* icon_caution] Do not attempt to remove the home button switch, as it is connected to components below the LCD plate.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利