跳转到主内容

修复你的物品

维修的权力

配件 & 工具

英语
中文

正翻译步骤 3

步骤 3
Try to keep the adhesive strips flat and unwrinkled during this procedure; twisted or wrinkled strips will stick together and break instead of pulling out cleanly. Additionally, do not press down on the battery as you pull the strips. Pressing on the battery creates pressure points that can snag and break the adhesive. Slowly pull one battery adhesive tab away from the battery, towards the bottom of the iPhone.
  • Try to keep the adhesive strips flat and unwrinkled during this procedure; twisted or wrinkled strips will stick together and break instead of pulling out cleanly.

  • Additionally, do not press down on the battery as you pull the strips. Pressing on the battery creates pressure points that can snag and break the adhesive.

  • Slowly pull one battery adhesive tab away from the battery, towards the bottom of the iPhone.

  • Pull steadily, maintaining constant tension on the strip until it slips out from between the battery and the rear case. For best results, pull the strip at as low an angle as possible, without snagging it on any of the iPhone's other components.

  • The strip will stretch to many times its original length. Continue pulling and re-grab the strip near the battery if necessary.

  • If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then proceed as instructed below.

在此过程中尽量保持粘合带平整且不起皱;扭曲或起皱的拉条将粘在一起并破裂而不能干净地拉出来。

此外,拉动拉条时请勿按下电池。按下电池会产生压力点,这些压力点会阻碍和破坏粘合剂。

将一个电池小拉条慢慢拉离电池,朝向iPhone 底部。

稳稳地拉动,保持条带上的恒定张力,直到它从电池和后壳之间滑出。为获得最佳效果,请尽可能以较低的角度拉动条带,而不要将其钩在任何 iPhone 的其它组件上。

拉条将拉伸至其原始长度的许多倍。如有必要,继续拉动并重新抓住电池附近的条带。

如果在拆卸过程中电池拉条断裂,请用手指或钝镊子取回剩余的粘合剂长度,然后继续拉动。

如果任何拉条在电池下方破裂而无法取出,请尝试取下剩余的胶条,然后按照下面的说明进行操作。

在开源创作共享许可协议下,你的投稿已被许可