菜单

你的设置

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的7本指南。

返回指南
英语
中文
上一步

正翻译步骤 7

步骤 7
To avoid straining the display cables, don't open the display all the way yet. Open the display to about a 45° angle, and use tweezers to peel off the adhesive between the display and the Force Touch gasket. Thread the adhesive around and behind the display cables to get it off completely.

  • To avoid straining the display cables, don't open the display all the way yet.

  • Open the display to about a 45° angle, and use tweezers to peel off the adhesive between the display and the Force Touch gasket.

  • Thread the adhesive around and behind the display cables to get it off completely.

为避免损坏显示屏电缆，请勿完全打开显示屏。

将显示屏打开约45°角，然后用镊子剥去显示屏和Force Touch垫圈之间的粘合剂。

将粘合剂穿过显示器电缆的周围和后面，使其完全脱落，然后向下按压垫圈以重新粘附到盒子上。

如果Force Touch垫圈本身松动且不会向下弯曲，则应更换垫圈下方和垫圈与显示屏之间的粘合剂。

[* icon_caution] To avoid straining the display cables, don't open the display all the way yet.
[* black] Open the display to about a 45° angle, and use tweezers to peel off the adhesive between the display and the Force Touch gasket.
[* black] Thread the adhesive around and behind the display cables to get it off completely, and press the gasket down to re-adhere to the case.
[* icon_reminder] If the Force Touch gasket itself comes loose and won't stick back down, you should replace both the adhesive underneath the gasket and between the gasket and the displaycompletely.
[* black] Thread the adhesive around and behind the display cables to get it off completely, and press the gasket down to re-adhere to the case.
[* icon_reminder] If the Force Touch gasket itself comes loose and won't stick back down, you should replace both the adhesive underneath the gasket and between the gasket and the displaycompletely.

在开源创作共享许可协议下，你的投稿已被许可。