修复你的物品 社区 商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南。

返回指南
英语
中文
上一步

正翻译步骤 8

步骤 8
Use the flat end of a spudger (or an opening tool) to pry the touch screen cable connector up off the upper logic board.

  • Use the flat end of a spudger (or an opening tool) to pry the touch screen cable connector up off the upper logic board.

  • Now that the front panel is out, check it for damage. If the plastic surround is not flush with the front face of the glass panel, gently peel it off and stick it down.

  • Be careful not to scratch the front panel on the underside of the black portions, as the scratches will be visible once the device is reassembled.

  • Be sure to clean both the face of the display and the inner surface of the front panel, as any dust or fingerprints will be trapped inside the Touch once it is fully reassembled.

用撬棒扁平的一端（或专用开启工具）将触摸屏线缆连接器从主板上方撬起。

到此前面板应该已经拆下，立刻检查它是否有损坏。如果一周的胶条没有整齐地与前面的玻璃面板分离，轻轻地把它扯下并粘回去。

要小心避免刮伤前面板背面的黑色部分，因为刮掉漆的地方在设备被重新装好之后是看得出的。

确保清洁显示屏表面和前面板的内面，因为任何灰尘或指纹在touch被装配复原后会被困在里面。

在开源创作共享许可协议下，你的投稿已被许可。