跳转到主内容
英语
中文

正翻译步骤 2

步骤 2
Start by taking out the 4 obvious screws, two on each side. You'll need a long-necked T6 driver if you want to get these out cleanly. (At least 1" / 25mm.) The pro tech toolkit does not have one long enough, so I used a slightly hacked hex key on two of them (stripping the heads) and ended up drilling out the other two because the hex key is not a good fit.
Remove 4 side external screws
  • Start by taking out the 4 obvious screws, two on each side.

  • You'll need a long-necked T6 driver if you want to get these out cleanly. (At least 1" / 25mm.)

  • The pro tech toolkit does not have one long enough, so I used a slightly hacked hex key on two of them (stripping the heads) and ended up drilling out the other two because the hex key is not a good fit.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可