翻译步骤＃18 - Removing iPad 3 4G Front Panel - iFixit

取消

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的153指南。

英语

中文

上一步下一步

正翻译步骤 18

步骤 18

Slide the opening pick along the top edge of the iPad, pulling it out slightly to go around the front-facing camera bracket.

The adhesive along this section is very thick, and a fair amount of force may be required. Work carefully and slowly, making sure to not slip and damage yourself or your iPad.

If the adhesive has cooled too much, replace the iOpener along the top edge and continue working. If the iOpener has cooled too much, reheat it.

Slide the opening pick along the top edge of the iPad, pulling it out slightly to go around the front-facing camera bracket.
The adhesive along this section is very thick, and a fair amount of force may be required. Work carefully and slowly, making sure to not slip and damage yourself or your iPad.
If the adhesive has cooled too much, replace the iOpener along the top edge and continue working. If the iOpener has cooled too much, reheat it.
If the opening pick is getting stuck in the adhesive, "roll" the pick as shown in step 9.

在开源创作共享许可协议下，你的投稿已被许可。